WILO Hi CONTROL 1

The Wilo HiControl 1 series is used for borehole pumps to enable automatic operation. Wilo-HiControl 1 protects the pump against operation with low volume flow. Thanks to a volume flow sensor and pressure sensor, Wilo-HiControl 1 automates the pump between two values, the start-up pressure and the shut-down volume flow. If the pressure in the network is lower than the start-up pressure, Wilo-HiControl 1 starts the pump. The pump continues to operate until the volume flow falls below the value of the shut-off volume flow.
The interior small container prevents water hammering and cycling.
Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible pumps for domestic water supply.

Special features
Simple installation
Especially compact design makes it suitable for many types of installation locations
High operational reliability due to electronic fault signal
Protection of the connected pumps due to built-in protection against low water levels
Simple operation due to clear operating state display
No additional diaphragm pressure vessel required
Perfect corrosion protection, due to rust-free materials
Inline version with input and output in vertical axis and uniform thread connections, suitable for direct connection to the pump housing or wall surface installation with a wall bracket (accessories).
Note
The HiControl 1 may be installed only in vertical position with the output at the top.